General:

The must have accessory for on the go pointing.

Why I designed this:

The tiny hand was such a hit, I wanted to start adding accessory options

Printing notes:

Layer height: .15 or finer is ideal, but aesthetic only

Recommended Material: PLA

Supports: The clip should be printed on it's side to avoid splitting on the layer lines. Supports are needed on the upper dovetail edge only.

Infill: 15% Gyroid or triangle

Walls: 3-4

Other Modifiers: Print as oriented

Material Quantity: ≈23grams

 Once printed, just slide the clip onto the mating feature. It clips lightly into place.

I printed from PLA on Centauri Carbon at .16 layer height with 15% rectilinear infill and 3 walls.

_____________________________________________________________________________________________________________

Don’t forget to follow me, post a make, leave a like, or tell me what you don’t like so I can make improvements.

Thanks, and Happy Printing!

Also check out:

[https://fabtechmfg.square.site/](https://fabtechmfg.square.site/)