I was in need of a simple stand for a typical square humidity sensor. I'm currently using it inside of a filament storage dry box, but there are plenty of other use cases for it.

I printed mine out in PLA with a 0.2mm Structural setting, 15% infill, and a HF0.4 nozzle on a Core One.

I highly recommend organic supports  specifically for the long overhang on the top. You shouldn't need supports for the text. I manually painted on the support points and had success with that.

These are the specific sensors I used: [https://www.amazon.com/dp/B08P3QJJZL](https://www.amazon.com/dp/B08P3QJJZL) however anything with the same dimensions will do just fine. The dimensions of the square cutout in the model are 45.5mm x 26.6mm.