I got tired of marrying the last bits of resin and waiting for it to all leave the bottle was a bore. So I designed these two parts. The round cuff fits around anycubic resin 1k bottles. The hook rests in the print platform of Phrozen 8K printers. Press fit the L shaped part into the cuff's hole. The bottle is then placed upside down in the cuff (facing down) remove the cap while it is over the resin vat (verify it is the correct resin and vat). Then pour what loose resin is left into the vat while tilting the hook up and onto the raised build platform (see image). Take care closing the lid, as if it hits the drip hanger , it will swing and pour resin on your machine. To avoid this; once it is installed and hanging, rotate the parts so the corner of the L part is resting against the build tray. And always close your lid slowly.

This assembly fits Anycubic and Phrozen bottles. 3.5 or 87mm diameter bottles 1kg

Note: make sure the seal on the cap is removed,
otherwise, resin can be kept from leaving the bottle and will give a false impression of it being empty, waiting for you to tilt it just right to release the contents onto something you care about.

~These parts are marked CCA but I don't care for that- I couldn't find a CC0 setting which is so bogus. I prefer no attribution and simply use it and be safe.~
Trans Lives Matter