Split into 3 parts and added slot for bolt in handle and hole for embedded nut in blade. Intended for 6-32 hex head machine screw and a 6-32 hex nut.

You can probably omit supports on both blade and hilt. They're small enough holes.

Guard will need them under the ends.

EDIT:

Uploaded V2. Wider parts so there would be two extrusions on either side of the nut

6-32 hex nut is gonna be tight in the blade I actually ground mine off slightly on each side to make it fit. Might look at a square nut to save space. Hilt side fit perfectly. Hex head 6-32 may be harder to find so will probably make one that fits a regular pan head 6-32.

Print Settings

Printer:

JGMaker Artist-D

Rafts:

Supports:

No

Resolution:

Infill:

25

Filament:

n/a PLA

Category: Props