Simple box printed in spiral vase mode.  Customize to fit your junk and your drawer by scaling in the slicer.  I printed with 1 mm wide external perimeters (the wall is 1mm thick) with good success.  I have made tiny boxes (blue one in the drawer), and boxes that fill up the print area.  I found one roll of filament did not work well for these because the between layer adhesion was poor.  But the rest of the PLA that I tried worked great.  Make sure you use spiral vase mode or you will get a box full of infill.  I posted G code for a MK3S+ with a 0.6 mm nozzle in a couple different sizes.  The model is just a rectangular prism with radiused vertical edges.