Printing directions and safety

This print is designed for PETG, DO NOT USE PLA, IT MAY WEAKEN AND BREAK WHEN EXPOSED TO SUN

Set the wall count to at least four and enable supports for the lever arm. The main body of the clip should be printed upright for strength in the most important axis

Use blue threadlocker on the backpack clamp screws to make sure they don't work themselves loose

For safety I recommend wearing your neck strap when using the backpack mount, I don't take any responsibility if the mount fails and damages your camera

Mounting the camera

Camera is mounted using a tripod shoe. I use a K&F concept K234A0+BH-28L included shoe but some other 60-65mm arcaswiss shoes should work (verify if the shape matches before printing!)

Required hardware

• 1x 6mm x 18-20mm compression spring
• 2x M5x12mm screw (may need to be longer depending on your backpack)
• 2x M5 nut
• 1x M4x16mm or M4x20mm screw
• 1x M4 washer
• 1x M4 nut