Reasons to make a remix:

• Added a low-profile base to decrease minimal height to 72 mm
• Needed a flat bottom for an uneven surface
• Angular design

Configurations:

• Low profile base + short screw: 72mm - 108mm
• Normal base + short screw: 80mm - 130mm
• Normal base + long screw: 165mm - 220mm

You can also cut the screw in the slicer, so you can just chose the base, measure and clip the long screw to needed length. 

Also includes a nut to test if threads work on your printer.

I recommend PETG and 0.16 lh.