Holds:

1. AG13      x10
2. AG12      x10
3. AG5        x10
4. AG4        x10
5. AG3        x10
6. AG1        x10

Just drop the batteries into place. Simple as.

----------------------------------------------------------

Description:

This holder is for assorted button cell batteries. Each slot is labelled and there’s a separate section to keep empty batteries.

-------------------------------------------------

Size: 

131mm x 93.3mm x 16.5mm

 Width       Height       Depth

-------------------------------------------------

Extra information:

I couldn't find any assorted holders for small batteries so I decided to make one myself. Since each battery sits quite close together its hard to take them out without it pinging away from you. I made each slot quite a loose fit to accommodate for this. 

As for the filament, I personally used marble textured PLA from elegoo and then added a pause on the 75th layer then switched to black filament from elegoo (i don't have an ams). Hope you like it.

These are the batteries I made the holder for