This is the first flippable and clicking phone stand on Printables that can be carried on           key - rings, clicks on opening, closing and takes only 1.8 M of filament (5g of Generic PLA).

It is easy to print, needs almost no supports, can be printed with almost anything and for assembly, only 2 two drops of superglue are used. The axle is a bit of filament, that is clipped from the spool. The cap part needs to be printed 2 times. First, you need to insert a bit of filament into the first cap like in the first instruction image, and then put a bit of glue into the channel, then after hardening, insert it all into the two arms of the stand and glue the other cap from the other side with the channel not facing the arms (like in the images), for this step, you shuld use a helper M3 nut or something like that from the underside when pushing the cap onto the axle while the glue hardens, and that is all for the assembly, then, you can straight up use it on you phone, put it into your pocket to have it when it is needed, or clip it onto your keys with the built in carabiner on the end of the Lower part. 

*Might be small for some iphones and cases.

Please, those who print it, provide feedback so i can improve on it. Thank you☻