Modded this great design by @NateBorshch_2628425 by adding a Multiboard snap to his single hook. 

The inside of the snap has been reinforced to print the hook parallel to the printbed. 

Supports on the bottom of the V1 snap are crucial to ensure a good multiboard fit. I suggest using normal supports since then no brim is needed to keep it on the printbed. V2 can be printed without any support.

Printed in eSun ePLA Light I-Cold White & Elegoo PLA Orange

Based on the fantastic Multiboard system by Jonathan from Keep Making.

A special license applies to Multiboard remixes. Full details of the Multiboard license: [https://www.multiboard.io/license](https://www.multiboard.io/license)

Edit 2025-12-02 - uploaded V2 of this remix this one should be printable without any supports.