A girlfriend of mine her birthday is comming up, so I thought I would make her something she likes. She gave us nicknames for a event. So i put those on the picture.

I will also upload a nameless model, so you can put a name on it yourself.

I also uploaded a starbookmark without a name plaque:
[http://www.thingiverse.com/thing:1404960](http://www.thingiverse.com/thing:1404960)

Print Settings

Notes:

This size should be printed with a small nozzle, like a 0.25mm nozzle. Or the letters will look bad. I's are also hard to print because of the little dot on them (i). The extra amount of fillament extruded after a retract is too much and will make it look like a blob.

You could also scale it up to +-130% and print it with a 0.40mm nozzle just fine.

Category: Office