Print it with 0.2 layer (it is designed for it) and 0.4 noozzle. No support, no brim, except for the screws. Less than 2h for the body.

Use a different color for the screws if you want the eyes to pop out. You may leave the eyes hollow or fit a screw into them.

Print, remove built-in supports below the ball joints, move the parts until fluid. Then screw the screws in to tighten the model. Dont overtight

You will need a small electronics screwdriver.

please LIKE, DOWNLOAD (it help me to gain prusa points). Show me you makes. You can also follow me or even (let's dream a little…) suscribe to my club.