This is a stackable Slime! So-called because it is a Slime model from the Dragon Quest series with a divot in the bottom that allows it to perfectly fit over the spiky point of another Slime’s top.

It also spins pretty well, so that’s fun!

The included 3mf file has plates for both multiple-extruder printers to print the whole Slime in one go, and single-extruder printers to print the pieces separately. It also has a plate that prints by object, and a plate with a whole bunch of slimes that all purge to infill to try to minimize purging, because why not.

Careful with the small pieces! You might need a brim to print them properly, but if you do have one, make sure you peel it off thoroughly!

There are little grooves in the eye pieces that dictate what direction to put them in; they’re labelled left/right from the Slime’s perspective.

If you want to print a different color, simply swap out the blue color in the 3mf for your desired color.

If you want one without a big hole in the bottom for the base, check out the model this was remixed from.

If you are going for a classic Slime Stack look, you can print a green Slime Knight Slime for the top, an orange She-Slime for the middle, and the classic blue Slime for the bottom.

If you want to print a Metal Medley, just print three Metal Slimes out in silver.

Enjoy! I’d love to see what combinations and creations you can come up with!