Maker Notes: Philadelphia Eagle Clock

Print Settings

• 0.15mm Layer Height
• 15% Infill
• Textured PEI Plate (PRUSA)
• Sized for an MK4 printer

PLA

• Top:

1. ESUN Basic Green – Layer 1, 2h 34min
2. ESUN Pine Green – Layer 2, 32 min
3. PRUSA Galaxy Black—Layer 3, 21 min
4. PRUSA Silver – Layer 4, 20 min
5. ESUN Cold White -- Layer 5, 14min

(Times may vary)

• Bottom:

1. PRUSA Galaxy Black

Clock Movement

TIKROUND Include Hands Quartz DIY 12888 Wall Clock Movement Mechanism Battery Operated DIY Repair Parts Replacement; 5mm Thread Length, 18mm Shaft Length (Amazon).

Notes

This is a large print. It does not require an MMU- there are 4 filament changes.  I used Nanopolymer Adhesive (Vision Miner) to promote adhesion and had no detachments. 

The clock was designed in Fusion 360. A f3d file is attached and is partially parametric. A 3mf file with filament changes is also included.  You can separate the parts in PRUSA Slicer for Printing.

Print the top and bottom parts.  Install the clock movement – you may need to trim the Eagle a bit.  Glue the bottom to the top with Epoxy.  Install the hands and battery.  Set the time.

Go Eagles!!!