Print Each Part Separately 🖨

IMPORTANT ⚠

For the strand with no base, use a 5mm brim so it doesn't fall.

SUPPORTS 🛠

• CAN be printed without supports, but you need to use a 0.12 mm layer height if you don't want to sacrifice quality.
• Be prepared for a little sanding or torching.

ASSEMBLY 🧩

1. Take the strand with no base and heat it up with a heat gun until it is slightly soft.
2. Take the low part and screw it into the one with a base.
   • ⚠ As these are molecular models, they must remain in the orientation they were printed. Otherwise, they won't fit.
3. Once the low part of the no-base strand touches the base, align it from above and hold it in place until it cools down. ❄