The Mini-IPSC Target Template!

Use shortened, sharpened nails in the holes to mark the vertices of each target zone (A zone, B zone, C, zone, etc) and trace the outside perimeter! Once finished and without letting the template move any, use sharpened nails to punch holes through the cardboard through the provided holes to mark your targeting zone corners. Then trace dot-to-dot in each zone with a ruler. It should look like the IRL image above when finished. 

 I'd recommend getting this if you'll be mass-producing targets:
[https://www.harborfreight.com/4v-cordless-power-cutter-56192.html](https://www.harborfreight.com/4v-cordless-power-cutter-56192.html) 

I have one and it makes it seamless. No need to fight with scissors. 

If you don't want to use scissors, an angle grinder with a cutoff wheel works good, be careful not to over-cut into the target itself. A rotary inset saw works good too but leaves rough edges which I hate.