You're on 3DFinder
We search Thingiverse, MakerWorld, and Printables at once so you get the best of each.
Description
This is a mountable enclosure for a toggle switch. It was specifically designed for the Gardner Bender GSW-121, however it should work for any similar toggle switch.
- Removable cover attaches with four m3 screws and has slots for four m3 square nuts.
- Two mounting holes on the back
- 10mm hole on the bottom, easily fits through heatshrink female spade connectors
- Recommend printing the body with supports enabled and the front of the body face down (rear mounting holes should be pointing up). You may need to put some support blockers around the screw holes, but I managed to clean mine out with a dental scraper tool.
8
Likes
75
Downloads
Category
Electronics
License
Creative Commons — Attribution
Files (4)
Main Body.stl
699.7 KB
Front Panel.stl
205.4 KB
Toggle Switch Box v3.step
127.5 KB
toggle_switch.3mf
255.4 KB
Like this model? Create a free account to save your favorites and come back to them later.
Create account