My old showerhead holder wasn't doing its job anymore so I designed one to be 3D-printed.

This is designed to fit a 25mm Pipe. 

It consists of 4 parts, is adjustable and easy to print. No suports needed, no adhesives and no screws, that could potentially rust.

While the the force on the shorter screw determines how strongly the clamp attaches to the 25mm pipe, the longer screw does NOT need to be tightened for a stronger hold! Loosen the longer one a bit until the teeth disengage, choose your angle and then only tighten until the teeth reengage again.

Print Instructions:

I used ABS. ASA and PETG should work too. No guarantees on PLA, might be too stiff.

I used 3 perimeters and 20% Gyroid infill. No need to go crazy.

Do the overhangs slow, or use smaller layer height.