This is a camping lamp with lampshade made when an existing lamp suffered catastrophic failure and we wanted to repurpose the led ring. ([https://www.amazon.co.uk/GlobaLink-Rechargeable-Collapsible-First-Aid-Emergency/dp/B07QYLHBNZ](https://www.amazon.co.uk/GlobaLink-Rechargeable-Collapsible-First-Aid-Emergency/dp/B07QYLHBNZ))

The lamp shade should be printed using vase mode and transparent filament to get the best light throw.

Print Settings

Printer Brand:

Prusa

Printer:

No

Supports:

0.2 mm

Infill:

20%

Post-Printing

The battery pack goes into the base. Wire up your light to the terminals, and connect a switch.

I used [https://www.amazon.co.uk/gp/product/B07GBBJMXX](https://www.amazon.co.uk/gp/product/B07GBBJMXX), that should fit perfectly into the cutout in the base.

The piece called light_base screws into bulb_holder using the two small holes and very small screws. Depending on the hardware you have available you may just want to stand the light source in or on the base.

Category: Sport & Outdoors