This is a remix of a pretty standard Floaty, but I gave it a slightly slimmer handle for comfort, a longer handle for ease of use but also nearly the maximum height for many 3D printers, and a flat bottom to make it possible to print without supports.

The flat bottom does allow you to stand it on flat surfaces, but I don't recommend that because it will be top heavy.

Update 1: I noticed that after only a few uses the mounting tabs at the top were cracking where they connect to the body. So I added more support for them in the model.

Update 2: a few more small tweaks to the mount at the top, and gave the bottom a small bevel. v3 is probably the final version unless anyone has problems with it.

Print Settings

Printer Brand:

Creality

Printer:

Yes

Supports:

0.15 mm

Infill:

Notes:

Since this is a tall narrow build I used 5mm brim to keep built plate adhesion, your mileage may vary.

I recommend minimal infill, and a thick shell. Maybe having no infill is possible, I used 5% and it printed fine.

I chose concentric as the pattern for the first layer to make it look better. It still isn't perfect because it usually has flaws on the bottom, but it is better.

Category: Camera