As part of the “2024 3D Printing Industry Awards” competition, I created this wonderful trophy with the iconic Benchy Boat. The Boat is my model. 

With the idea of success, I came up with concept 2 of the boat riding the waves of success. I thought that was fitting for an awards ceremony. 

Print the boat and base separately, then glue or insert magnets.

NOTE: Benchy model is not representative of a benchy “Bench mark” model. This boat model shouldn't be used for calibration and is just for the trophy only. Boat is scaled to fit 45mm limit of competition on the Binder Jet Part.

• The stand is approx 80mm High
• The Stand base is 80mm x 42mm
• The whole award is approx 114mm in height
• The boat is non-uniformly scaled down from 3D Benchy to fit within the 45mm limit. 
• The boat can be attached using 2 qty 10mm x 2mm Magnet. 
• Can be printed without text. You could then Glue a small plate with the wording printed on it like most trophies. The rectangle for plate is 36mm x 22mm

I printed mine with 

0.2 layer Height

15% infill (increase for a heavier print to give you that award-quality feeling.)

FOLLOW LINK FOR CONCEPT 1