I printed in PLA with 3 walls and 20% infill

BOM:

1x M3X18 Screw

1x M3 Nut

1x Elastic Band or 2x Wood screws

…yes its that short this time

Simply take off the monitor stand on the C270 and use a M3x18 screw and M3 nut to attach it to the mount. Make sure to not tighten it too much as it will break the thin plastic on the camera itself. Use an elastic band on the tabs to hold it in place or use the screw in one to screw into the leg of the lack

Thanks to [https://www.printables.com/@Klipperboi](https://www.printables.com/@Klipperboi) for the photos of the screw in photos :)