I could not find any tablet stands for my iPad the way I pictured it so decided to design my own. Created this one in Fusion 360.

Printing Instructions

1. No supports needed - just make sure to print on the side so it prints vertically as in the 3MF file. 
2. Print at '0.3mm DRAFT' with 0 infill to make printing faster. Prints in less than 8 hrs on an MK3S. You can add infill to make it heavier.
3. I printed it in PETG, add a brim if you're not sure about your first layer adhesion. Better to use brim if you print in PLA.

Design notes

• Viewing angles are 45 deg and 60 deg
• Thickness is 5mm
• 10mm clearance for the tablet - enough for a simple cover
• Total height is 20cm - so it fits in the MK3S
• Can also be used upside down - see photo

Update

Added a version with hearts instead of hexagons, enjoy!

If you print this, please post a make. Feedback and suggestions are appreciated!