Pretty straight forward, this is a set of basic covers for the Moza bases and wheels to protect against the contacts getting dusty or damaged when not in use. Technically anything that is using D1 QR's, so Simagic stuff, should be compatible too.

I've provided 2 different base caps with slightly different tolerances. I've provided 2 wheel side covers with different interface parts. I'm using the more clearance base cover, and the R2 of the wheel cover on my setup.

Print in PLA, ABS, ASA, PETG, whatever. In my pictures the base cap is in PLA+, the wheel covers are in ABS.

I recommend 4 walls, 4 layers top and bottom, and ~20% gyroid infill. Wait for parts to cool fully before checking the fit. The wheel covers are meant to be snug, but not hard to remove. If they are too tight, do not force them. Make a small scaling adjustment in your slicer and try again. Mine are printed as provided, no scaling. If your EM and/or extruder are not calibrated, there is a good chance these will be too tight.