This is my own version of "Car Roof Bar Rack Crossbars Mount by jschaftenaar".

It is basically the same idea but with following changes :

1. 4 screwholes intead of 2.
2. Base naworrer -adapted to my Thule's Wingbars Evo´s size.
3. Full piece a bit smaller due to limited bed size of my Ender 3 v2.
4. A little wider/stronger to compensate the fact that now is the piece is narrower.
5. Rounded / nicer edges.

On my Ender 3 v2 I had to remove the safe limits following this tutorial : [https://www.youtube.com/watch?v=Il1sierB4Yk](https://www.youtube.com/watch?v=Il1sierB4Yk) otherwise wasn't posible to print it flat.

Happy printing.

Print Settings

Rafts:

No

Supports:

200

Infill:

Category: Organization