About the model:

This is a hook I designed to fit on the end of a backpack strap as part of a sewing project. The key innovation for this V2 design was to make it removable, i.e. you can add and remove it from a loop without needing to unpick and resew the loop.

When I did my very unscientific testing on it (pulled it apart as hard as I could), it resisted very well, with only minor stress marks and no failure. So I'm pretty sure it wouldn't be the failure point for any reasonable use-case.

Honestly, it's pretty niche, but I'm uploading it on the off chance someone finds it useful :)

Print Info:

• No supports

• 0.28 mm Layer height

• PLA+

• Ender3 V2 Neo

Liked this model? If you are able to, you can support my work here: [https://ko-fi.com/purposefulcreation](https://ko-fi.com/purposefulcreation)

Have a wonderful day! :)