Designed to hold a bath towel.
81mm (3.14") tall.

MOUNTING HARDWARE:

I used #8x1-¼" screws and plastic drywall anchors that came in this kit:
[https://www.amazon.com/Plastic-Self-Drilling-Threaded-Self-Tapping-Mounting/dp/B086ZK7RBF/](https://www.amazon.com/Plastic-Self-Drilling-Threaded-Self-Tapping-Mounting/dp/B086ZK7RBF/)

INSTALLATION:

Align the bracket piece on the wall with the screw holes facing out and the pin hole at the bottom.
After attaching it to the wall, place the shell over the bracket and slide the pin through to secure it.

PRINTING DETAILS:

This was designed and tested for printing with a 0.2mm nozzle at 0.1mm layer height.
The larger seashell will probably print fine with a 0.4mm nozzle at a 0.2mm layer height.
The smaller one has a tight tolerance on the pin and already requires force to insert it.

The supports included on the .3mf file are sufficient and remove easily.
If using the .stl, be sure to enable supports or the inner roof will bow.

The smaller shell is printed at an angle to reduce the chance of bed adhesion issues.
Feel free to adjust if you like, but re-sizing will change the screw holes.

Each part was printed on it's own plate in order to reduce stringing.