A hard case for the iPhone 11.  The case has cutouts for the phone buttons and switch.  There's also an internal slot for a steel plate for magnet phone mounts.  The steel plate is aligned to not interfere with the wireless charging.

My case design is intended to slip into a belt mounted holder, but can be used as a general iPhone 11 case, too.

My print is made in 1.75mm eSUN PLA+ Silver filament, with 0.2mm layer height and 15% infill on a Bambu Lab X1 Carbon printer.  Print supports are required.

I hope that you can find this print useful, too. If so, you can support my work by buying me a coffee …
Buy Me a Coffee

Remember to leave me some feedback or even a tip to keep me enthused to make more of these drawings.