Simple headset stand inspired by markus710's headset stand.
Fits a 9.5mm wide RGB strip, the example uses a WS2812B strip running wled from an esp32.

Entire model prints in 5 pieces without support, make sure your bed leveling is perfect for the diffusor, only 1-2 layers thick depending on layerheight.

Backplate gets glued on at the end. (I just used 1 dot of superglue at the top and bottom for this)

 

NO SPACE INSIDE THIS MODEL FOR AN ESP32.

Other hardware used:

2x M3 threaded inserts
2x M3 hex bolts about 10mm

This is used to attach the base to the main body 

Could probably be glued together if you really wanted to.

 Short videoclip of it:

[https://www.reddit.com/r/BambuLab/s/jnc0uuBQzN](https://www.reddit.com/r/BambuLab/s/jnc0uuBQzN)