Você está no 3DFinder
Buscamos em Thingiverse, MakerWorld e Printables ao mesmo tempo para te dar o melhor de cada uma.
Descrição
NOTICE: Credit is given to RooShoo and link to their project is [https://www.thingiverse.com/thing:5266398](https://www.thingiverse.com/thing:5266398)
Print everything without supports EXCEPT the lens frames.
The face shell and lens includes holes for round circular magnets, of the following sizes.
4x of 6mm
4x of 8mm
Trim mesh into the lens clips as needed.
Sand down the face shell for comfort.
All sticking was done with Gorilla Glue, but can be done with any type of super glue.
There is a red mask over the shell. I will do the black web designs later with black fabric glue or hot glue.
I had a lot of trouble when printing because of the holes, so MAKE SURE ADHESION IS ON. This will save you a lot of filament, trust me.
If you are trying to save filament, don't print “spiderman_1_head_2_opt”. It is not extremely necessary, but would be nice and snug to have.
Good luck and ask questions!
