This piece is intended to be mounted on the wall but as you can see, it can sit upright as well, i just want everyone to know the intended use lol

For those with only 1 AMS

This is a 7 color print, I made this with 1 AMS system so it is possible but you will have to be vigilant with switching colors for the first 5 layers. For the first 3 layers, there are only 6 colors (Black, Blue, Red, Cyan, Pink, White) after layer 3, its changes to 5 colors (Black, Blue, Cyan, Grey, White).

Layers 1-3 are base colors

Layers 4-5 are shading

When you click print you should have Black, Blue, Red, Cyan loaded onto the AMS at the beginning. (Doesn't matter where just remember where you placed them for switching purposes) It'll ask you where Pink, Grey, and White are going to be loaded. You'll want to place them under the following:

Pink under Black/ White under Blue/ Grey under Red.

When switching:

Once a color has finished laying, wait for it to unload from the hotend then quickly and calmly unspool it and switch it with the proceeding color, load it into the AMS and whenever the next color is ready to print, it will automatically load into the hotend. Repeat the process for all 5 layers.

This is the order in which the printer will print colors according to where they are in the print itself

This arrow (>) means switch to the filament after the color has finished laying on each layer.

                                   Layers 1 - 3

           Layer 1                     Layer 2                         Layer 3

(1) Black > (5) Pink   > |(1) Black > (5) Pink  > |(1) Black > (5) Pink                 

(2) Blue >  (6) White > |(2) Blue > (6) White > |(2) Blue >  (6) White              

(3) Red                       > |(3) Red                 >      |(3) Red                                      

(4) Cyan                     > |(4) Cyan               >     |(4) Cyan                                 

> Switch to Black after Pink has finished laying on layer 3

> Switch to Blue after White has finished laying on layer 3

> Switch to Grey after Red has finished laying on layer 3

> Keep Cyan the same

 You should have Black, Blue, Cyan, Grey on your printer by the start of Layer 4

                                    Layers 4 - 5

       Layer 4                           Layer 5         

(1) Black                    | (1) Black                    

(2) Blue > (5) White | (2) Blue > (5) White

(3) Cyan                    | (3) Cyan

(4) Grey                    | (4) Grey

Keep White on for the rest of the print

For those with more than 1 AMS, hit print and enjoy!!

Light Installation

1. Put aluminum (shiny side up) at the bottom of the baseplate, adhere with glue.
2. (Skip if you don't plan on using a grommet for the wire hole) Get a 16mm Closed Grommet, cut a thin line down the middle, but don't cut it entirely in half.
3. Insert led strip, install along the walls of the print, cut to size.
4. (Personal preference to ensure longevity of adhesive) Hot glue along the lines of the led strip, grommet hole
5. Insert faceplate.
6. Sip on a nice cold beer and admire your handiwork.

**I highly recommend turning retraction settings on if you haven't already. Its a vital setting to have on with these light displays. it helps eliminate the chances of blobs or stringing**