Adjustable stop for use on an MFT, or compatible, table-top w/ 20mm Dog Holes w/ 96mm spacing. This one is sized to be going over 2 spaces with an adjustable range of 192 mm. Printed in PETG HF - although expect other filaments will be fine assuming your printer is tuned properly (as sizing is critical for the dog holes).

You need to install at least one M5 Threaded insert into the base (although 2 can be convenient for reversing the top without having to remove the base from the table) - I used these [https://www.amazon.ca/dp/B0CS6WFCGZ](https://www.amazon.ca/dp/B0CS6WFCGZ)

 You will also need an M5 knob (and possibly washer) to hold the sliding top in place on the base.