Stand for Remarkable 2, iPad, iPad Pro, Android Tablets (up to 15mm 

This tablet stand is intended to be a fairly minimal looking stand that can still handle the weight of a large tablet. 

✨ Features

• Stable platform for your tablet (no wobble under use)
• Charging slot cut out in the base so you can feed in a charging cable if you like when used in portrait mode
• Measured to fit a Remarkable 2, so the side USB port can still be accessed for charging

7mm Slot Profile

• Max recommended tablet (+case) thickness: 6mm
• Initially designed for my Remarkable 2, the 7mm slot print profile should also work well with iPads (without a case). 
• Be sure to measure the total thickness of your tablet before printing!

15mm Slot Profile

• Max recommended tablet (+case) thickness: 14mm
• Designed for a Remarkable 2 + Folio case, this may also work for thicker tablets or tablets with a case. 
• Be sure to measure the total thickness of your tablet before printing!

— 

Print details

Be sure to enable supports when printing, and make sure the supports are covering all parts of the seat where the tablet will sit. My support settings are (in Bambu Studio):

• Enable support: on
• Type: tree(auto)
• Remove small overhangs: disabled
  • This is very important to prevent print failure
• Everything else unchanged

This model used about 88.5g of filament when I printed it using SUNLU PLA White+ using a custom profile, taking around 4 hours and 25 minutes on my Bambu Lab A1 at default speed. It should be a bit quicker with Bambu Lab PLA.