Made this hueforge of my dog standing in a bunch of leaves. I took the hueforge and added my information behind it and used it as a luggage tag for my recent trip. The model that has been posted is without the luggage tag hole at the top. This is also the perfect size for a bookmark. 

If printing without AMS, make pauses at the layer heights and manually make the swap. If printing with one AMS, replace the black with white after the black has finished. When sending print job both white and black should occupy the same AMS slot.

Filaments Used:

Elegoo Rapid PLA Plus - Black

Bambu Basic - Red

Elegoo - Gray

Hatchbox - Wood

Bambu Matte - White

Using different filament will create different results, however it is not necessary to use the exact filaments I used. The Wood filament can also be replaced with a beige or lighter brown color. Matte white can be replaced with basic white.

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Swap Instructions:
    Start with Black
    At layer #6 (0.56mm) swap to Red
    At layer #9 (0.8mm) swap to Gray
    At layer #13 (1.12mm) swap to Wood
    At layer #16 (1.36mm) swap to Jade White for the rest.