Check out my other Around the House models: [https://makerworld.com/en/collections/6181334-around-the-house](https://makerworld.com/en/collections/6181334-around-the-house) 

UPDATE 07-04-25:  I added a NEW bottle cap insert Profile that uses the PCO-1881 Standard thread.  This is used by most 20 oz water bottles.  I use the Dasani 20 oz bottle.  The V2 cap still works for some weirder bottles like the Ice Mountain 23.7 oz bottle. 

UPDATE 06-14-25:  I added a solid top cap in case you wanted to use it just as a feeder without the water bottle.  I also modified the water bottle cap to help with inserting and screwing in bottles (V2).

UPDATE:  Added a deck railing mount so you can easily pick up and clean out the bird feeder.  I had to snip off the points of the screws since I didn't have the right length of screw.

Bird Feeder/Bath

I printed @Sammm2907_362232 Bird bath but didn't want the water to fill all the way to the top.  So, I re-modeled it as close to the original but I made it in two parts for easier printing.

Once the holes get blocked by water, the water stops flowing.  Once water goes below those holes, it starts filling up again.

Recommended to use PETG, ABS or ASA for outdoor.

If you want to download or remix my models, you can go to OnShape here - [https://cad.onshape.com/documents/0c6c20b2a3893e676acf46b2/w/0d787a8672939329f800bcdb/e/36085e067e3f6d9d1f0bb159?renderMode=0&uiState=64a98d962227c45aa4b17341](https://cad.onshape.com/documents/0c6c20b2a3893e676acf46b2/w/0d787a8672939329f800bcdb/e/36085e067e3f6d9d1f0bb159?renderMode=0&uiState=64a98d962227c45aa4b17341)