Are you troubled by misalignment of the printed board? To solve this problem, I designed this special guide block, with streamlined guide rails and angled design, so that it can well guide the printing panel to slide into the bottom in the correct direction. Even if you close your eyes, you can complete it smoothly, Looks cool? Try printing it now!

  ( I am challenging to create 100 practical models. Follow me to get update reminder ) 

Tips

• Suitable for P1 and X1 series
• It is only suitable for single-sided installation because there is insufficient space on the left and right sides, and the double-sided installation print plate is difficult to push in smoothly.

How to use

Please follow the video to complete the following steps:
1. First put the model vertically and press it down gently (hold the bottom of the hot bed with your fingers and press up and down).
2. Press the left plane of the model until you hear a "click".
3. Observe whether the side of the model is vertical and the plane is horizontal.