Version 2 of the GameCube Game Display! Changed the storage style so the game cases are now stored horizontally. This model comes with two options for 10-game or 12-game storage. Once again, AMS is NOT REQUIRED for this print!

Print the body with your favorite color on its back with no supports needed. I printed the GameCube body on the Textured PEI plate, but all other pieces on a Smooth Plate and 3D Effects Plate.

Supports are only needed for the controller port as it's oriented vertically. Printing the controller port horizontally always resulted in warping.

The entire build takes only 3 build plates, and less than 24 hours to print all the pieces. Print all the pieces separately and snap the power button, GameCube emblem, and controller port into their respective slots in the GameCube body. No glue or epoxy necessary!

Please note that the controller port should be installed with the rounded side facing downwards to be fully “GameCube accurate”.

Did everything I could to make each component print separately, so AMS is not needed (except for the GameCube Emblem), but created 3 variants of the emblem, so you can choose what works for you.

1 AMS version w/ black and white

1 “monochrome” inlay version

1 “flat” version without the GameCube logo