Hi,
I created a low-material battery holder, for the Einhell series.

Inspirational base, but mine is fine-tuned and much more accurate in size. Securely holds small 4.0Ah batteries (or smaller), but also fits larger 5.2Ah and above. (The larger batteries are supported by a reinforced, thicker mounting section.)

It was important to securely hold the battery, because it can be mounted not only on a wall, but also on a toolbox. (The battery won’t fall out; it holds very precisely.) No supports needed. ;)

For best results, please dry the filament well before printing.

Sized for 4 mm wood screws or smaller. (Maximum head diameter: 8 mm — if it’s larger, the screw head may get stuck in the upper part of the battery.)

I hope others will find it useful too!

If you liked my work, please recommend it to others, or hit the Like button. Thank you very much.

Happy printing!