This zip tie anchor is a redesign of PeterEllens' version ([http://www.thingiverse.com/thing:24187](http://www.thingiverse.com/thing:24187)) but I've made a little change so that it prints easily without supports. I've also included a small notch in the bottom to make it easy to pry off the built table. It is 1" square - simply apply a piece of 1" wide double-sided foam mounting tape to the back and you'll have a secure mounting point for small to medium sized zip ties. You can also scale it by 75% if you want to use 3/4" foam tape.

Print Settings

Printer:

UDIO

Rafts:

Supports:

No

Resolution:

Infill:

30%