After needing to hang many pictures and getting frustrated with the process, I have decided to spend more time creating something to help me out than actually doing what my wife said. There are 2 profiles to print, one that fits the A1 Mini and one that fits the others.

you can apply a drop of glue or some tape to hold the level in place if the tolerances arent right.

You may need to add a piece of tape or drop of glue to fit the level in place depending on your tolerances. This fits 9.5mm levels

Please note: ensure your bed is level and your plate is clean. I had no issues with bed adhesion, but use a brim if needed. The dove tale joints are suppose to be hard to get it for a sturdy rod.

This is the first version I have published, but 5th version that I have designed. It is very simple. To assemble:

1. Connect the dove tail joints by firmly pressing them together or lightly tapping them together. Most people use a hammer but I used my phone.
2. Add the level to the center most rod
3.  Next feed that rod through each of the screws
4. Thread the nut firm enough to hold the rod into place
5. Insert the pointy nubs of the screw where the nails will hold the picture
6. tighten the nuts onto the screws
7. Put the Picture Perfect Hanger up to the wall, with a level on top, and push the points into the wall. You have now marked the locations of the nails for your picture. Congrats!