IMPORTANT!! before printing: scale the part named “frame lamp top” to 98% instead of its current 96%. It will give a warning message but it should not be a problem. If you do not do this, you will get two seperate parts for the lampshade. You could reattach them using a 3D pen but it wont be as clean.

This lamp is printed in two parts. The top part has a solid framework for attachment to the bottom piece while at the same time it prints a single wall outside for the lamp shade. 

The bottom piece and top piece are connected using a screwed fitting that clamps them together. I used one for a e14 lightbulb. Please check if the diameters of the rings match the design - 40mm should work. 

For example the Strala from ikea should fit but it might be more complex to fit through the cable hole.

Let me know what you think and if i should make any adjustments! cheers