I was playing around with a CAD system and this is the result  - an Infinity Pyramid.

It is an easy print and a nice sculpture for your desk, especially if you use a dual colour filament. For the pictures I even used a triple colour filament from Elegoo.

Print preparation:
Make sure that your print bed is clean and grease-free and use a quality brand, dry filament. If you are having bed adhesion issues you can always try the new Bambu SuperTack plate (do not forget to change the plate in slicer).

Print settings:

Use the 0.2mm standard settings for everything. Support is not needed. Three walls and 10% gyroid infill is recommended. Reduce the speed to 100mm/s for the outer walls and to 250mm/s for everything else. This slower speed will enhance quality especially when using silk filaments.

See my 3mf print profile for details.

Assembly:
Not required

If you want to support me you can leave a tip at ko-fi.com/blecheimer.

Disclaimer:
This work by blecheimer is licensed under CC BY-NC-SA 4.0. The shown model must not be used commercially.
Copying this model to other 3D printing websites is not allowed without my permission.