Summary

This is a double wall hook to print in place.
Just print the hook and bend it together.
If the hooks won't fit together, heaten the printbed uo to ~70 degree and place the hook on the printbed to warm it up a bit. Then the two parts will snap together.

If you like the hook, you might also be interested in this model. It is a hook that works on the same principle, but it also has options for hanging something on the top.

[https://makerworld.com/de/models/1018981-double-wall-hook-v2#profileId-999897](https://makerworld.com/de/models/1018981-double-wall-hook-v2#profileId-999897)

IMPORTANT: Use pan head screws

Rafts: 

No

Supports:                      

No

Resolution: 

0.20 mm

Infill:                      

50%

Filament: MISC PLA / PETG / ASA
MISc