Hi everyone

This help you to create nice stamp on paper or post cards.

You can replace die and make different stamp.

There are a few types of shapes: hear, star, smile etc but if you want create some custom stamp please use Stamp_Template.stl.

It was designed to print with 0.2mm and this is important to get nice looking effect.
 

Effect depend on paper (can be a photo, postcard or even aluminium foil) thickness and force you use to make the stamp. Try with different papers but best result you get with 0.15 - 0.20 mm.

If you want to create onw stamp I recommend to use 0.6mm die depth and 0.2 or 0.4mm chamfer on edges. In Fusion 360 I used 0.2mm 0.6mm chamfer for "tenon" part and 0.4mm 0.6mm for "mortise" part.

Printing does not require any support. Only for Bold it is good to use small brim. After printing the bold smooth surface with a sand paper or sharp knife.

It is not required to print Stamp_Case_Holder.stl but it helps to keep all parts in one place.