This is my take on the Maker World Clock Components Kit-011 

The second hand that is provided with the kit will need to be permanently modified for the use of this clock-

-bend the thin metal arms sticking out from the mounting pin several times, they will eventually break off cleanly, with ease. 

-small dab of glue in the 3D printed second hand then insert the mounting pin inside (shown in photos)

-insert clock component kit and lock to the face with the provided hardware

-slide each hand over the clock module in order (they fit nicely, don't press hard)

-slide face into the outer ring, its sized just right to allow to you remove the face if needed

-screws for base need to be cleaned by tightening and loosening them a few times (progressively making them tighter each time) before they go in smoothly

This clock has a lot of potential for custom faces, I plan to do a couple for around the house and one that has wacky colors for my oldest son. I hope you enjoy this design and if you have any questions/requests please reach out! 

Thanks for checking this out!

-Chad the dad