I use one of these as a compact (and more stylish!) compost bin and another one as a small trash can close to my dog grooming table.  The bin itself is a simple (if a bit long) print with no support, but the lid prints in place and no assembly nor supports is needed for the hinge.  Contrary to other trash/compost cans i own, the lid on this one can be opened with only one finger and will stay open (and not just flip over on the side).  The lid can be removed when emptying and there should be enough tolerance to put a bag in it.  I printed it with Elegoo Rapid PLA at .2mm.  No support needed.