Hi everyone,

This is my first complex model I made for my children that I'm excited to share with you all.

The model can be stacked as one or the player can spread this in three parts.

I have put the parts on 3 plates. The only one requiring AMS would be the mushrooms.

Printers I have used to create this model: A1 mini, A1 and P1S.

Print settings:

I have printed the House and Tree with and without support, both work well.

I printed the house roof with only one wall loop, that is to force the slicer to add inside infill, making the roof look like its made of wood when light is shining at it.

Mushrooms

Please ensure at least 8mm of outer brim, keep them compact to avoid them to come off loose during printing.

In BambuStudio go to: Others>Bed adhesion>Brim type: Outer brim only.

Door frame and leaf:

I have inserted some leftover PLA at top and bottom. Please cut the top part at an angle, flush with the door frame to allow it to fit in.

I'd recommend not to bother to push the PLA all the way through, but rather use one small bit for each end.

If you're struggling with inserting the PLA in, just heat it over and slightly pull the filament so it gets thinner(wish this would work on me too).

Please help me if you know a better way to make sturdy hinges for this size. I have done some iterations but were too frail. There will be some friction between right side of door and frame. This was the only way I could ensure that the door hinges will not fail after multiple uses.

My aim is to make this into a lamp eventually, but I'd also love your input. 

You may struggle to screw in the mushrooms due to deck thickness. I know that the deck could have been made thicker but I want to save on filament/prin time.

I'd love to hear your feedback, please don't hold back if you believe anything can be changed for better.

Thank you!