Designed For LTT 20mm Screwdriver bits, I uploaded a file that will fit most standard full size ¼ hex bits.

There are TWO Plates One holds 12 bits, the other holds 16 and are labeled as such. Both use the same magnets. 

The No Magnet Profiles do not require bar magnets, and instead has tighter tolerances to make up for the lack of attraction. Still have optional base magnet slots. 

Print-Pause Magnets

This model is designed to be paused at Layer 75 (Z=15mm) for magnet insertion. And Layer 40 (Z=8.00mm) for the full size variant.

If using the uploaded Profile this has already been set and you can just hit print, even from bambu handy.  

I highly recommend to place the back magnet first, then the front, and do the middle one last while holding the other two down, once placed you shouldn't have to worry about them. 

Magnetic Bit Holder Utilizes 3x (30x10x3) Bar Magnets

I had some left over magnets from my LTT Gridfinity V2 w Magnetic Bit Storage and decided to make some additional bit storage for future sets, and figured anyone who printed the 24 bit version would have these left over as well. 

Still has the Optional slot-in style base magnets, these are 6x2 round magnets. 

As always, feel free to leave any suggestions or comments below, you can also reach me directly on here or discord.