Before anybody says anything in the comments, I will NOT apologize for art.

So I was playing with my Dummy 13 when I had a terrible thought… Dummy Thicc 13

Thus, I made a butt for the Dummy 13. The only reason this took me longer than an hour is because it was my first time using TinkerCAD, I literally just made a butt shape and stuck it onto the stand attachment.

Some caveats:

• As previously implied, this is my first time making any sort of model for 3D printing. I almost certainly did something wrong. If you have any suggestions for improvement, I'm open to them!
• I don't think I can get the butt attachment off without some sort of tool.
• The original creator said ASA was the best material for the structure. Since I don't have any ASA, I printed and sliced mine in PETG-HF. I did this because the stand attachment was included as one of the structure pieces, so you should probably not print this piece in PLA.
• I have put this under the same CC attribution license as the original Dummy 13. Nobody else needs to take the blame for this. You can totally sell it if you want, though.
• I know the red PETG in the pictures makes my Dummy 13 look like a baboon. I only had red and translucent blue PETG on hand, and nobody likes translucent butts (unless you're into ghosts, I guess).
• The butt goes into the stand hole. This means you can't attach the stand to the model. I suppose there may be ways around that, but they're too terrible to think about.
• This is butt only. If you want the rest of it, you'll have to go to the Dummy 13 page.
• Original Dummy 13 by Lucky 13 Toys.

Happy printing!