Project: Foglia 1.hfp
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 54.95x50mm in size
You may print at higher layer heights below the Min Depth of 0.48mm
The Max Depth is 2.2mm and the Actual Depth is 2.2mm

Filaments Used:
    PLA+ Esun Flame Red Transmission Distance: 2
    PLA BambuLab Basic Orange Transmission Distance: 5
    PLA+ Esun Yellow Transmission Distance: 6
    PLA+ Esun Yellow Light Transmission Distance: 8
This print uses 4 unique filaments

Swap Instructions:
    Start with Flame Red
    At layer #13 (1.12mm) swap to Orange
    At layer #17 (1.44mm) swap to Yellow
    At layer #19 (1.6mm) swap to Orange
    At layer #21 (1.76mm) swap to Yellow
    At layer #23 (1.92mm) swap to Orange
    At layer #25 (2.08mm) swap to Yellow Light for the rest.